Toshiba 40E220U - Using the Auto Aspect Feature

UsingtheTV'sfeatures _(_
Using the Auto Aspectjeature
6 To save the new settings, highlight Done, and then press the
ENTER button.
To revert to the factory defaults, highlight Reset and then press
the ENTER button.
The adjustment range is from -5 to +10.
UsingtheAutoAspectfeature
When this feature is set to On, the TV will automatically select the
picture size when one of the following input sources is received:
o',o A 480i, 480p, 720p, 1080i digital signal from the
ANT/CABLE input
o',o A 480i signal from the ColorStream HD or Video input
o',o 480i, 480p, 720p, 1080i, 1080p, or VGA (60Hz) signal from
the HDMI 1 or HDMI 2 input.
A,_pectRatio of Signal Source Automatic A,_pectSize (automatically selected
when Auto Aspect is On)
4:3Normal 4:3
4:3LetterBox TheaterWide2
16:9Full Full
Notdefined(noID-1dataor Thecurrentpicturesizeyouselected,see"Selecting
HDMI®aspectdata) thepicturesize"onpage64.
NOTE Theauto aspect ratio featureis not applicable to the PC input.
To turn on the auto aspect ratio feature:
1 Press the MENU button and open the Picture menu.
2 Highlight Theater Settings, and then press the ENTER
button.
3 In the Auto Aspect Ratio field, select On.
4 To save the new settings, highlight Done, and then press the
ENTER button.
To revert to the factory defaults, highlight Reset and then press
the ENTER button.
To turn off the Auto Aspect ratio feature, Select Off in step 3 above.