(2/3)
2. Unplug TV, and then Insert the USB mass storage device to the USB slot of the TV.
3. Plug TV.
Software updating starts.
If Software updating does not start and the front LED lights red, then press [Power] key on
Remote Control to start Software updating.
4. After updating complete, unplug TV and remove the USB mass storage device.
5. Plug TV, then check the updating by using self check screen.
Refer to “Confirmation of Software updating” section on next page.
6.
Update to the newest SW.
This model can be updated from aerial or network to the newest Software.
Refer to the user manual of this model for the updating method.
To Next Page
Loading...
