E.g. If Bit D7-0 = 0101 1010, Hex data is 0x5A.
Exit from Service Mode
Pressing POWER button to turn off the TV once.
Setting Data of Signal Unit
After replacing Main board, the following initialization is required.
Note:
In case initialization by setting wrong PANEL is done, there is a possibility of abnormal
display.
1) Check the picture carefully. If necessary, adjust any adjustment item above.
Perform "Auto tune" on the owner's manual.
7 0 1 1 1
8 1 0 0 0
9 1 0 0 1
A 1 0 1 0
B 1 0 1 1
C 1 1 0 0
D 1 1 0 1
E 1 1 1 0
F 1 1 1 1
CAUTION: Whenever using new Main board to the set, setting the PANEL
data according to Panel option data.
To Next Page
Loading...
