3. The parts indicated with " " have special characteristics, and should be replaced with
identical parts only.
4. Voltages read with DIGITAL MULTI-METER from point indicated to chassis ground,
using a color bar signal with all controls at normal, line voltage at nominal AC volts.
5. Waveforms are taken receiving color bar signal with enough sensitivity.
6. Voltage reading shown are nominal values and may vary ±20 % except H.V.
= Electrolytic capacitor
= Mylar capacitor
file://C:\Documents and Settings\Alexsandr\Local Settings\Temp\Rar$EXa0.555\42C
To Next Page
Loading...
