• Before connecting any external equipment, turn off all
main power switches�
• The unauthorized recording of TV programmes, DVDs,
video tapes and other materials may infringe upon the
provisions of copyright law�
•
1 connection: Use for the Scart/Phono jacks adaptor
(supplied)�
• The
COMPONENT VIDEO INPUT
consists of
three component video signals (
Y
,
P
B
/C
B
,
P
R
/C
R
) and
provides better picture performance� These terminals
can only be used with component video compatible
equipment e�g� DVD video player, etc�
• Additional equipment and cables shown are not supplied
with this TV�
Connecting an audio system
- digital -
You can enjoy high quality dynamic sound by connecting
the TV to an audio system�
Notes:
• DO NOT connect the
DIGITAL AUDIO
output
terminal to the AC-3 RF input of a Dolby Digital
Receiver with a built-in Dolby Digital decoder.
• Connect the
DIGITAL AUDIO
output terminal to the
OPTICAL
input of a receiver or processor.
• Refer to the owner’s manual of the connected
equipment as well.
• When you connect the TV to other equipment, be
sure to turn off the power and unplug all of the
equipment from the wall outlet before making any
connections.
• The output sound of the TV has a wide dynamic
range. Be sure to adjust the audio amplifier’s
volume to a moderate listening level before turning
on the power. Otherwise, the speakers and your
hearing may be damaged by sudden high volume
audio.
• Turn off the amplifier before you connect or
disconnect the TV’s power cord. If you leave the
amplifier power on, the speakers may be damaged.
Warning:
When you are connecting (via the
DIGITAL AUDIO
output terminal) an AV decoder that does not have
Dolby Digital decoding function, be sure to set
PCM
for Digital Output menu (
-
page 40). Otherwise,
the speakers and your hearing may be damaged by
sudden high volume audio.
Connecting an amplifier equipped with a
Dolby Digital decoder
To Next Page
Loading...
