Wireless LAN and your Health
Wireless LAN products, like other radio devices, emit
radio frequency electromagnetic energy� The level of
energy emitted by Wireless LAN devices, however, is far
less than the electromagnetic energy emitted by wireless
devices such as mobile phones�
Because Wireless LAN products operate within the
guidelines found in radio frequency safety standards
and recommendations, TOSHIBA believes Wireless
LAN is safe for use by consumers� These standards and
recommendations reect the consensus of the scientic
community and result from deliberations of panels and
committees of scientists who continually review and
interpret the extensive research literature�
In some situations or environments, the use of Wireless
LAN may be restricted by the proprietor of the building
or responsible representatives of the organization� Such
restrictions may apply in environments where the risk of
interference to other devices or services is perceived or
identied as harmful.
If you are uncertain of the policy that applies to the use of
wireless devices in a specic organization or environment,
you are encouraged to ask for authorization to use the
Wireless LAN device prior to turning on the equipment�
How to use this Dual Band Wireless LAN Adaptor
• If this device is going to be operated in the frequency
range of 5�15 GHz to 5�35 GHz, it is restricted to indoor
use�
Setting up the Network
You can select the Network Type.
1
From the
Preferences
menu, press
Network Setup
and press
OK
�
Note:
If the Dual Band WLAN Adaptor is not
connected, Wireless cannot be selected.
3
If you selected
Wired
, see “
Advanced Network
Setup
” on page 52�
Wireless Setup
Notes:
• This feature is greyed out when the Dual Band
WLAN Adaptor is not connected or Network Type
is set to Wired.
• Continued connection of AP (Access Point) is not
guaranteed. The connection may be disconnected
while watching TV.
• Do not remove the Dual Band WLAN Adaptor
when
Network Type
is set to
Wireless
or wireless
communication is active.
There are 3 methods for Wireless Setup:
Easy Setup (WPS)
If the AP supports WPS, this method can be used�
• WPS is an industry standard designed to make
connection of wireless LAN equipment and security
setup easy. WPS will automatically congure all
wireless settings�
Assisted Setup (setup by using the AP’s notification
information)
Network Name, Authentication, and Encryption are
decided based on information from the AP. You will
manually set the Security Key�
Manual Setup (manual input of all settings)
Easy Setup using PBC (Push Button
Configuration)
1
From the
Preferences
menu, select
Network
Setup
and press
OK
�
2
Press
s
or
r
to select
Wireless Setup
and press
OK
�
3
Press
s
or
r
to select
Easy Setup
and press
OK
�
To Next Page
Loading...
