430 Series
9. Disconnect the flexible cable.
10. Remove four M2x3 screws and remove the FDD from the bracket.
Figure 4-13 Removing the FDD
Installing the FDD
To install the FDD, follow the steps below and refer to Figures 4-13 back to 4-10.
1. Seat the FDD in the metal bracket and secure four M2x3 screws.
2. Connect the flexible cable.
3. Set the plate in place and seat the FDD in the lower plastic cover.
4. Set the upper plastic cover in place and secure six M2x6 screws. Press firmly to
engage latches.
5. Slowly insert the FDD module into the computer. Be careful to insert the drive
straight and press gently so the drive is flush with the computer.
6. Hold the FDD module flush to the computer and push the lever down until it
snaps into place.
7. Lock the release lever lock.
8. Install the optional memory module, optional PC card, and battery pack as
described in Sections 4.4, 4.3, and 4.2.
To Next Page
Loading...
