430 Series
Installing the CD-ROM Drive
To install the CD-ROM drive, follow the steps below and refer to Figures 4-15 and 4-14.
1. Push the CD-ROM drive fully into the case.
2. Connect the flexible cable to the drive.
3. Replace the front cover and press firmly to engage latches.
4. Secure the frame to the drive with four M2x3 screws and three M2x6 screws.
5. Slowly insert the CD-ROM drive module into the computer. Be careful to insert
it straight and press firmly so the drive is flush with the computer. The release
lever will close partially.
6. Hold the CD-ROM drive module flush to the computer and push the lever down
until it snaps into place.
7. Lock the drive release lever lock.
8. Install the optional memory module, optional PC card, and battery pack as
described in Sections 4.2, 4.3, and 4.4.
To Next Page
Loading...
