430 Series 4-53
Installing the FL (TFT)
To install the FL, follow the steps below and refer to Figures 4-50 and 4-49.
1. Place the FL in the frame. Lift up the white plastic cover to route the FL cable.
2. Replace the white protective tape covering the FL.
3. Rotate the two parts of the LCD PCB (connected by a flexible cable) back into
place and press firmly to connect the LCD PCB to CN2 on the LCD module.
Replace the tape.
4. Secure the LCD PCB with one M2x2.3 black screw, two M2x3.5 silver screws,
and two M2x5.5 silver screws.
5. Seat the metal FL cover. Slide it to the right to secure the latches.
6. Be sure the extension on the metal cover is under the edge of the LCD PCB.
7. Secure two M2x3.5 silver screws and replace the gold protective tape.
8. Install the LCD module, FL inverter board, display mask, optional PC card,
optional memory module and the battery pack as described in Sections 4.19, 4.17,
4.16, 4.4, 4.3, and 4.2.
To Next Page
Loading...
