Toshiba 4400 Series

To Next Page

To Previous Page

4400 Series Installation and Operation Manual – 64527-008

FIGURE 9.11: INSTALL SAFETY SHIELD

FIGURE 9.12: CONNECTION SINGLE LINE DIAGRAM

Main Page

Default Chapter7
- Table of Contents7
1 Introduction11
2 General Safety Instructions12
- Symbols12
- Signal Words13
- Qualified Personnel13
- Factory Authorized Personnel13
3 Important Safety Instructions14
- Unintended Usage15
- Disclaimer15
- General Maintenance16
- Transporting17
4 Unpacking18
- General Instructions18
- Unpack the 15-30Kva Model UPS (with Casters)18
- Unpack the 50Kva Model UPS (with Casters)20
- Unpack the 80-100Kva Model UPS21
- Inspection/Storage22
5 Warning Labels23
6 Storage/Operating Environment29
- Storage Environment29
- Precautions29
- Maintenance Precautions31
- UPS Component Information32
7 Installation Safety33
8 Installation36
- Unpacking36
- UPS Clearance36
- UPS Anchorage38
- 15-50Kva Anchorage - Standard39
- 80-100Kva Anchorage - Standard40
- Power Cable Access41
- UPS Parts Identification - 15-30Kva43
- UPS Parts Identification - 50Kva45
- UPS Parts Identification - 80-100Kva47
9 UPS Wiring49
- Wiring Safety49
- One-Line Diagram50
- Parallel Battery Cable Installation Instructions54
- Power Terminal Blocks and Cable Sizing58
- External Breakers63
- Grounding Wire63
- Control Wiring64
10 Communication Interfaces65
- Remote Contacts65
- UPS LAN Shutdown Signal Operation65
- Rs-232C66
- Remoteye Network Card66
- Specifications67
- 15-30Kva Specifications - W/ Internal MBS And/Or Battery Backup67
- Estimated Runtime on Internal Batteries - 15-30Kva71
- 15-30Kva Specifications - W/ External Battery Backup71
- 15-30Kva Efficiency Vs. Load (Typical)75
- 15-30Kva Thermal Loss Vs. Load (Typical)75
- 50Kva Specifications - W/ Internal Battery Backup76
- Estimated Runtime on Internal Batteries - 50Kva78
- 50-100Kva Specifications - W/ External Battery Backup79
- 50-100Kva Efficiency Vs. Load (Typical, no Transformer)82
- 50-100Kva Thermal Loss Vs. Load (Typical)82
12 Operator Interface83
- Operator Controls83
- Operator Controls - Light Emitting Diodes (LED)84
- Operator Controls85
- Touch Screen Display86
- Header Bar87
- Footer Bar87
- Touchscreen Data and Controls88
- Quick Access Toolbar89
- 4400 Menu Tree90
- Toolbar: Security91
- Toolbar: Buzzer ON/OFF91
- Toolbar: Touch ON/OFF91
- Toolbar: QUICK VIEW ON/OFF92
- Tab: Main - RUN/STOP93
- Tab: Monitor95
- Tab: Setup97
- Setup: Calibrating the Touchscreen99
- Tab: Record100
- Tab: Help101
- 4400 Parameter Definitions101
- System Fault Messages102
- System Warning Messages103
- System Mode Messages104
- System Status Messages104
13 UPS Operation106
- Standard UPS Operation (no Internal MBS)106
- Battery Low Voltage Tolerances110
- Audible Alarm Functions111
14 Options112
- Replacement Air Filters112
- Remote Monitoring System - Remoteye 4112
- Remote System Monitoring - Remote Radar112
15 External Layouts/Dimensions/Shipping Weights113
Appendix A - Dimensional Drawings115
Appendix B - Command Parameter Definitions Table121
Appendix C - Installation Planning Guide128
Appendix D - Internal XFMR Unit Input/Output Cabling Guide131
- D.1 - UPS Power Lug Cable Capacity and Torque Specifications131
- D.2 - Input Cable Size for 3-Phase/4-Wire + G131
- D.3 - Output/Bypass Cable Size for 3-Phase/4-Wire + G132
- D.4 - Cable Size for 3-Phase/3-Wire + G133
- D.6 - Battery Cabling133
- D.7 - Input Transformer Current for Given Input Voltage134
- D.8 - Output Transformer Current for Given Output Voltage134
Appendix E - Index135

Toshiba 4400 Series - Page 57

Table of Contents

Other manuals for Toshiba 4400 Series

Related product manuals