77
4400 Series Installation and Operation Manual – 64527-008
12.5 Header Bar
The Header Bar on the graphic display panel displays three system parameters: the System Load, Current Status, and
System Time.
2
1
3
Header Bar Components
No. Function
1 System Load – Load per each phase as percent of full load. Low – Less than 10% Load.
2 Current Status – UPS status at the moment. (Status is delayed by a few seconds)
3 System Time – Current time in AM-PM format
FIGURE 12.4: HEADER BAR DISPLAY COMPONENTS
12.6 Footer Bar
The Footer Bar on the graphic display panel displays three system parameters:
2
1
3
INVOLUPSOL BYPASS
Footer Bar Components
No. Function
1 Fault – Displays last fault sensed by UPS. A Fault causes the UPS to switch to bypass
and it will not automatically reset.
2 Warning – Displays last warning sensed by UPS. Multiple frequent warnings of the same
type may induce a fault condition.
3 UPS Mode – Current state of UPS.
FIGURE 12.5: FOOTER BAR DISPLAY COMPONENTS
To Next Page
Loading...
