88
4400 Series Installation and Operation Manual – 64527-008
Tab: SETUP (cont.)
Pressing an active button will cause a list of parameters to be displayed (See previous page). Pressing a listed parameter
will activate a display appropriate to the parameter selections available If the parameter cannot be edited at the current
security level, the display will not change. If the parameter can be edited or changed, an appropriate keypad will dis-
played as shown below. Either a alpha/numeric keypad, a multiple choice, or binary choice display will appear.
After entering data or selecting an options, press WRITE to save the selections, or QUIT to leave the current value un-
changed.
TABLE 12.3: TOUCHSCREEN KEYPAD IDENTIFICATION
Button Action
Clear Delete all characters on input line
Space (Space bar)
Recall Restores previous entered value
Move cursor one space left or right
DEL Delete character to right of cursor
BS Back Space – Delete character to left of cur-
sor
ABC Set Keypad to capital letters (A,B, C...)
abc Set Keypad to lower case letters (a, b, c...)
123 Set Keypad to numbers (1, 2, 3...)
./- Set Keypad to write Special
Characters ( . , – : / )
Write Write information (Enter)
(Pressing Quit without rst pressing Write
will cause the newly entered data to be lost.)
Quit Exit keypad.
Example 2 – Multiple Choice Display with
Default value Marked (*)
Example 3 – Binary choice (On/O,
Enable/Disable, Contact A/Contact B)
Example 1 – Alpha/numeric display.
To Next Page
Loading...
