Toshiba ACE-tronics G9 ASD - Page 225

ACE-tronics G9 ASD Installation and Operation Manual 215
My Function Percent Data 4
Program  My Function  My Function Data
This parameter is used to set the trigger threshold level of the analog signal of
the My Function Percent Data 4.
The analog signal is selected using the Input Setting number from Table 10 on
pg. 242.
Direct Access Number — F921
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Ye
s
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Percent Data 5
Program  My Function  My Function Data
This parameter is used to set the trigger threshold level of the analog signal of
the My Function Percent Data 5.
The analog signal is selected using the Input Setting number from Table 10 on
pg. 242.
Direct Access Number — F922
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Ye
s
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Frequency Data 1
Program  My Function  My Function Data
This parameter is used to set the trigger threshold level of the analog signal of
the My Function Frequency Data 1.
The analog signal is selected using the Input Setting number from Table 10 on
pg. 242.
Direct Access Number — F923
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Ye
s
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Frequency Data 2
Program  My Function  My Function Data
This parameter is used to set the trigger threshold level of the analog signal of
the My Function Frequency Data 2.
The analog signal is selected using the Input Setting number from Table 10 on
pg. 242.
Direct Access Number — F924
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Ye
s
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Frequency Data 3
Program  My Function  My Function Data
This parameter is used to set the trigger threshold level of the analog signal of
the My Function Frequency Data 3.
The analog signal is selected using the Input Setting number from Table 10 on
pg. 242.
Direct Access Number — F925
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Ye
s
Minimum — 0.00
Maximum — 200.00
Units — %
My Function Frequency Data 4
Program  My Function  My Function Data
This parameter is used to set the trigger threshold level of the analog signal of
the My Function Frequency Data 4.
The analog signal is selected using the Input Setting number from Table 10 on
pg. 242.
Direct Access Number — F926
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Ye
s
Minimum — 0.00
Maximum — 200.00
Units — %
F921 F926
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com