4 SETUP AND PREPARATION BEFORE OPERATION
4 SETUP AND PREPARATION BEFORE OPERATION
4.1 Pre-Operation Procedure
This section explains the preparatory procedure for operating the AJ65VBTCU-
68ADVN/ADIN.
START
Start data link.
Make offset/gain setting?
Offset/gain setting (Refer to Section 4.5.)
END
No
Yes
Create a program.
Create a program. (Refer to Chapter 5.)
Create a program.
Mode select switch setting
(refer to Section 4.3, Section 4.4)
4.2 Precautions When Handling
The precautions when handling the AJ65VBTCU-68ADVN/ADIN are described below:
CAUTION
Do not touch the pins while power is on. Doing so can cause a malfunction.
Ensure that no foreign matter such as chips and wire-offcuts enter the module.
Foreign matter can cause a fire, failure or malfunction.
Do not disassemble or modify the module.
Doing so can cause a failure, malfunction, injury or fire.
Do not touch the conductive and electronic parts of the module directly.
Doing so can cause the module to malfunction or fail.
4
To Next Page
Loading...
