Toshiba B-415 - TO CHARGE THE BATTERY PACK

E4-2
4. LOADING AND REMOVING THE BATTERY
ENGLISH VERSION EO1-33014
4. LOADING AND REMOVING THE BATTERY
• TO CHARGE THE BATTERY PACK
This printer includes no battery charger. Charging the battery requires an exclusive battery
charger. Please order the following one to your authorized TOSHIBA TEC representative if neces-
sary.
Part Name Lithium Ion Battery Charger
Description B-415-CHG
1 Connect the AC power cord to the charger.
2 Install the battery pack(s).
3 Connect the AC plug to a wall outlet.
The POWER lamp and the CHARGE lamp will light up and charging will begin. The CHARGE
lamp indicates how much the battery pack is charged.
NOTES: 1. When a fully charged battery pack is installed, the CHARGE lamp will once light up
orange then light up green.
2. Both of the battery charging receptacles are available, however, two of the battery packs
cannot be charged at the same time.
CHARGE lamp Charged
Orange on 0% to 90%
Orange flash 91% to 99%
Green on 100%
2
3
1
CHARGE
ERROR
POWER
CHARGE
ERROR