ENGLISH VERSION EO1-33014
4. Tear off the printed media upward or downward with the cutter.
NOTE: Do not pull the media out of the printer, as this will misalign the print position of the next
label.
Media
9. SELF-DIAGNOSTIC TEST PRINT
Fig. 8-2
9. SELF-DIAGNOSTIC TEST PRINT
1. Turn the power on while pressing the [FEED] button. Three LED lamps light up. After about 5
seconds, they extinguish, then the first label of the test print is issued.
For GH24 and GH34 models
9. SELF-DIAGNOSTIC TEST PRINT
For GH25 model
E9-1
PROGRAM VERSION FMRM0072201 V2.0 2800 (FONT:0200)(BOOT:A900)
PRINTER ID 00123
FORM VERSION 0000000000 0000000000 0000000000 0000000000
SRAM CHECK 512KB
SENSOR CHECK R:2.9V T:0.5V P:1.9V H:+25°C A:+25°C
BATTERY LEVEL 8.3V (OVER 220 LABELS)
TONE ADJUST +00 PARAMETER [B-415] [PC-850] [0]
FEED ADJUST +0.0mm MODEL NAME B-415-GH Series
HEAD CHECK OK
PEEL THRESHOLD 2.0V
PRINT MODE TPCL-LE
SERIAL NO. 3S000001
IrDA IrCOMM
PROGRAM VERSION FMRM0072002 V2.0 2800 (FONT:0200)(BOOT:A900)
PRINTER ID 00123
FORM VERSION 0000000000 0000000000 0000000000 0000000000
SRAM CHECK 512KB
SENSOR CHECK R:2.9V T:0.5V P:1.9V H:+25°C A:+25°C
BATTERY LEVEL 8.3V (OVER 220 LABELS)
TONE ADJUST +00 PARAMETER [B-415] [PC-850] [0]
FEED ADJUST +0.0mm MODEL NAME B-415-GH Series
HEAD CHECK OK
PEEL THRESHOLD 2.0V
PRINT MODE TPCL-LE
SERIAL NO. 3S000001
IrDA IrCOMM
0001cc4084fd
To Next Page
Loading...
