Toshiba B-EP Series - Page 36

CHAPTER 3 INTERFACE
B-EP Series
3-5
• Status in the compatible mode for the B-SP series
00H: Normal state (idling)
01H: Cover open state
02H: Command syntax error (including Ir packet error)
03H: Paper jam
04H: Label end
05H: Cover open error
06H: Broken head dots error
07H: Thermal head excessive temperature (including ambient temperature error,
abnormal battery temperature, and battery excessive temperature)
08H: Flash ROM write error
09H: Flash ROM erase error
0AH: Low battery (Print failure)
0BH: Operating (including wait for strip, pause state, writable character/PC command
save mode, wait for battery recovery, wait for head temperature reduction, and wait
for motor temperature reduction)
0CH: Communication error * In the RECEIPT mode or for RS-232C connection only
0DH: Normal end + Label end
0EH: Flash ROM storage area full state
10H: Normal issue end
37H: Charging error
( 38H: Bluetooth setting successfully completed)
Response status for automatic status transmission
39H: Bluetooth setup error (including initialization error)
• Battery status .. The battery charge status is indicated in 5 levels.
(B-EP2DL)
01H: 7.2 V or less (Print failure)
02H: 7.3 V to 7.4 V (remaining No. of printable labels: Approx. 1 to 30)
03H: 7.5 V to 7.7 V (remaining No. of printable labels: Approx. 30 to 150)
04H: 7.8 V to 7.9 V (remaining No. of printable labels: Approx. 150 to 300)
05H: 8.0 V to 8.4 V (remaining No. of printable labels: Approx. 300 or more)
(B-EP4DL)
01H: 14.0 V or less (Print failure)
02H: 14.1 V to 14.6 V (remaining No. of printable labels: Approx. 1 to 30)
03H: 14.7 V to 15.2 V (remaining No. of printable labels: Approx. 30 to 150)
04H: 15.3 V to 15.9 V (remaining No. of printable labels: Approx. 150 to 300)
05H: 16.0 V to 16.8 V (remaining No. of printable labels: Approx. 300 or more)
NOTE: The remaining number of printable labels may vary according to the contents to
be printed and the ambient environment.
• CRC ................ 2-byte hex data (in order from Low to High)