CHAPTER 3 INTERFACE
B-EP Series
3-7
• Detailed status in the compatible mode for the B-SP series
“00”: Normal state
“01”: Cover open state
“02”: Operating (including wait for strip, pause state, wait for battery recovery, wait for
head temperature reduction, wait for motor temperature reduction, and writable
character/PC command save mode)
“06”: Command syntax error (including Ir packet error)
“09”: Normal issue end + Label end
“11”: Paper jam
“13”: Label end
“15”: Cover open error
“17”: Broken head dots error
“18”: Thermal head excessive temperature (including ambient temperature error, battery
abnormal temperature, and battery excessive temperature)
“36”: Low battery
“37”: Charging error
(“38”: Bluetooth setting successfully completed) Response status for automatic status
transmission
“39”: Bluetooth setup error (including initialization error)
(“40”: Normal issue end) Response status for automatic status transmission
(“41”: Normal feed end) Response status for automatic status transmission
“50”: Flash ROM write error
“51”: Flash ROM erase error
“54”: Flash ROM storage area full state
• Status type ...... Indicated in 1-byte data
“1”: Status Request Command
“2”: Automatic status transmission
• Remaining No. of labels .... Indicated in 4-byte data
“0000” to “9999”
• CRC ................ 2-byte hex data (in order from Low to High)
To Next Page
Loading...
