- 159 -
6.6.9.2.4 Bluetooth Setting
6.6.9.2.4.1 Device Nickname for Assembly Process Test Setting
This setting is to identify the device nicknames.
F A C T O R Y T E S T O F F
Device nickname for assembly process
test is not used.
[PAUSE]
F A C T O R Y T E S T O N
Device nickname for assembly process
test is used.
[PAUSE]
Default value: OFF
<Supplemental Explanations>:
y When set to “ON”, the device nickname is “FACTORY TEST”.
y When set to “OFF”, the device nickname is “TOSHIBA TEC BT”.
y When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE]
key is pressed.
y When the [FEED] and [PAUSE] keys are simultaneously pressed, the display returns to the system
mode menu.
y When the [FEED] key or [PAUSE] key is pressed for 0.5 seconds or more during this setting, repeat
mode is enabled and the key pressed is repeatedly entered.
y The change in the parameter setting becomes effective when the [POWER] key is pressed after
setting, then stored in the backup memory.
To Next Page
Loading...
