Toshiba B-EP Series - Linerless Setting (LINERLESS)

- 73 -
6.6.2.2.4 Linerless Setting (LINERLESS)
This setting is for using a linerless label.
L I N E R L E S S O F F
Linerless setting is disabled.
[PAUSE]
L I N E R L E S S O N
Linerless setting is enabled.
[PAUSE]
Default value: OFF (Linerless setting is disabled.)
<Commentary>
y When linerless setting is enabled:
x On V1.0D or earlier, no back feed is performed.
x On V1.0E or later, the back feed amount becomes less, compared to when the linerless setting
is disabled, as described below. Accordingly, an unprintable area increases at a print start
time.
When linerless mode is turned off (common to the 2-inch and 4-inch heads)
Command mode
Back feed amount
(Unprintable area when starting printing immediately after a back feed)
TPCL
B-SP series compatible mode ON B-SP series compatible mode OFF
7.3 mm (3.0 mm) 9.3 mm (1.0 mm)
Label
Back feed fine adjustment enabled Back feed fine adjustment disabled
7.3 mm (3.0 mm) 5.0 mm (5.3 mm)
Receipt
2.0 mm
ECR/POS
When linerless mode is turned on:
(2-inch head)
Command mode
Back feed amount
(Unprintable area when starting printing immediately after a back feed)
TPCL
B-SP series compatible mode ON B-SP series compatible mode OFF
7.3 mm (3.0 mm) 7.3 mm (3.0 mm)
Label
Back feed fine adjustment enabled Back feed fine adjustment disabled
7.3 mm (3.0 mm) 5.0 mm (5.3 mm)
Receipt
2.0 mm
ECR/POS