28
Before using a peel-off unit
When issuing labels in the peel-off mode, pull out the
peel-off roller before loading a label roll.
1. Open the Top cover, and push the Peel-off Cover
by the ▲ marks with your thumbs in the direction
of the arrow.
2. Pull out the Peel-off Roller until the both edges
completely come out with a click
Refer to “Loading the Media” on the previous page
and set a label roll.
NOTES:
1. For the B-EP4DL series, DO NOT PULL the center
of the Peel-off roller hard. Doing so may break the
Peel-off roller.
2. Do not forcibly pull out the Peel-off roller or push it
into the printer, otherwise the Peel-off roller may
break.
How to put back the Peel-off Roller
1. Slightly hold down the Peel-off Roller Cover, and
insert the Peel-off Roller under the Peel-off Roller
Cover.
2. Hold down the Peel-off Roller Cover, push it into
the printer in the direction indicated by the arrow
until it clicks.
Peel-off Roller Cover
Peel-off Roller
Peel-off Roller Cover
Peel-off Roller Cover
Peel-off Roller
Peel-off Roller Cover
To Next Page
Loading...
