Toshiba B-EP2DL - Before using a peel-off unit; Peel-off Roller Setup; Replacing the Peel-off Roller

Before using a peel-off unit
When issuing labels in the peel-off mode, pull out the peel-off roller before loading a label roll.
Open the Top cover, and push the Peel-off Cover by
the ▲ marks with your thumbs in the direction of the
arrow.
Pull the Peel-off Roller until it clicks.
Refer to “Loading the Media” on the previous page
and set a label roll.
Notice
For the B-EP4DL series, DO NOT PULL the center of
the Peel-off roller hard. Doing so may break the Peel-
off roller.
 How to put back the Peel-off Roller
Slightly hold down the Peel-off Roller Cover, and
insert the Peel-off Roller under the Peel-off Roller
Cover.
Push the Peel-off Roller Cover into the printer in the
direction indicated by the arrow until it clicks.
Peel-off Roller Cover
Peel-off Roller Cover
Peel-off Roller Cover
Peel-off Roller
Peel-off Roller Cover
Peel-off Roller