3. REPLACING THE IMPORTANT PARTS EO18-33025
(Revision Date: Mar. 27, 2009)
3.6 Replacing the Stepping Motor
3-16
5. Replace the stepping motor with a new one, then reassemble in the reverse order of
removal. Be sure to apply FLOIL to the gear when reassembling.
NOTE:
Make sure that the stepping motor is mounted in the correct position and the thermal
conductive grease is applied to the thermistor to keep good contact with the stepping
motor case.
6. After replacing, perform a diagnostic test print or print a sample label to make sure the
printer performs correctly for the following points.
• Printing is performed correctly.
• No noise is generated during the print operation.
LUBRICATION
Gear: FLOIL
To Next Page
Loading...
