2. SUPPLY SPECIFICATIONS EO10-33024
2.4 SPECIFICATION OF RFID TAG (for B-EX700-RFID-H1-QM-R)
2- 12
NOTE: The degree of poor printing quality differs depending on height of a chip/antenna used.
8) Ambient Temperature
Low temperature deteriorates wireless performance, under which conditions writing data on an RFID
tag may fail.
9) Head-up Back feed
When an RFID label is used, a back feed may be required before an issue depending on the location
of an RFID tag in the label.
A printer without the ribbon saving module may not be able to perform a back feed properly because
the print head may be caught by an edge of the label. For this reason, the ribbon saving module must
be installed in the printer when media, which requires a back feed before an issue, is used.
RFID-tag
Embedded area
Poor printing may occur in
this area due to bump.
5 mm
5 mm
Media feeding
direction
Poor printing may occur in
this area due to bump.
To Next Page
Loading...
