3. OPTIONAL KIT EO10-33024
3.8 Wireless LAN Board: B-EX700-WLAN-QM-R
3-10
MAC Address:
MAC address is described on the wireless LAN module and the accessory sticker.
It is required when using the MAC address filtering function of the Access Point (AP). Please describe it in
the installation manual, etc. which is managed by end-users.
The MAC address can be confirmed by the maintenance counter print in the system mode.
Specification:
1) Hardware
Item Description
Standard IEEE802.11b/g
Enabled Device B-EP2DL/B-EP4DL Series
Operating Temperature 0°C to +50°C
Destination Japan USA Europe
Frequency
(Center Channel)
2412 to 2484MHz 2412 to 2462MHz 2412 to 2472MHz
Channel 1 to 14ch 1 to 11ch 1 to 13ch
Spacing 5MHz
Transmission
method
Conforming to IEEE802.11b DSSS method
Channel Depending on the country
IEEE802.
11b
Data transmission
speed/
Modulation
11/5.5Mbps:CCK
2Mbps:DQPSK
1Mbps:DBPSK
Transmission
method
Conforming to IEEE802.11g OFDM method
DSSS method
Channel Depending on the country
Transmission speed/
Modulation
IEEE802.
11g
Data transmission
speed/
Modulation
54/48Mbps:64QAM
36/24Mbps:16QAM
18/12Mbps:QPSK
9/6Mbps:BPSK
Antenna Chip type antenna (Built-in module)
802.11b 13dBm(19.95mW) Max Aerial power
802.11g 11dBm(12.59mW) Max
2) Software
Item Description
Connection mode (Refer to Note 1) Infrastructure, Adhoc
Default Country Code JPN
Default IP Address 192.168.xxx.yyy Set the printer ID for xxx,yyy.
Default Subnet Mask 255.255.0.0
Default ESSID TOSHIBATEC
Security IEEE802.11i
Cryptography WEP (64/128bit), TKIP(WPA), AES(WPA2)
Authorization Shared Key (for WEP), PSK, PEAP, TLS,
TTLS, MD5, LEAP, EAP-FAST
Browser Microsoft IE5.01 and greater
Protocol (Refer to Note 2) TCP/IP,Socket,LPD（LPR）,DHCP/WINS,HTTPD,（SNMP）
Wireless LAN Parameter Setting and Status
monitor (Refer to Note 3)
Parameter Setting: Command （PC Setting Tool）
Status monitor: via HTTP
To Next Page
Loading...
