Toshiba B-EX4 SERIES - Page 122

5. SYSTEM MODE EO18-33027
5.3 DIAG
5-26
Internal serial I/F check
EX.232C NG
OK: Normal data
NG: Abnormal data or the loop-back jig is not connected.
Internal serial interface
External serial I/F check (Supported by the B-EX4T1-TS25-R V2.0 or later, B-EX4T1-G/T C1.1A or later,
and B-EX4T2-G/T C1.1 or later)
SIO NG (0111)
Bit configuration (x3x2x1x0)
x0: Fixed to 1
x1: Fixed to 1
x2: Fixed to 1
x3: Presence of the optional board (0: RS-232C PC board not installed)
(1: RS-232C PC board installed)
OK: Normal data
NG: Abnormal data or loop-back jig is not connected.
External serial interface
RFID module check (U2/U4 module series only)
RFID OK #00RV972 (EU0) R01 Module revision (U2 series only)
Destination
RFID module version
OK: Normal state
NG: Erroneous state
RFID module
RFID OK #10A A0 0 (EU0) R00 Module revision (U4 series only)
Destination
RFID module version
OK: Normal state
NG: Erroneous state
RFID module
Module versions and LCD message
B-EX700-RFID-U2-US-R
Version
LCD message
R02
US, KR2, AU, TW (Use of AU and TW is prohibited.)
B-EX700-RFID-U2-EU-R
Version
LCD message
R11
EU0, IN0 (Use of IN0 is prohibited.)
JP: Japan
EU0: Europe
US: North America
CN2: China
AU: Australia
KR2: Korea
TW: Taiwan
IN0: India
EU0: Europe
US: North America (Prohibited)
AU: Australia (Prohibited)
KR2: Korea
TW: Taiwan (Prohibited)
CN2: China
IN0: India (Prohibited)