5. SYSTEM MODE EO18-33027
5.4 PARAMETER SET
5-40
Example of TYPE2
[Case 1] Specified number of labels = 5,
A label end is detected while the 3rd label is printed.
(1st)(2nd)(3rd)
↑
After issuing 3rd label completely, the printer stops printing, displaying “NO PAPER 2”.
When printing is restarted, first the initial feed is performed, then 4th and 5th labels are
printed. Finally, all of 5 labels have been finished.
[Case 2] Specified number of labels = 5,
A ribbon end is detected while the 3rd label is printed. Unfinished label length is 30 mm or more.
(1st)(2nd)(3rd)
↑
After the 3rd label is printed for 20 mm, the printer stops printing, displaying “NO RIBBON 2”.
When printing is restarted, first the initial feed is performed, then 4th and 5th labels are
printed. Finally, 1st, 2nd, 4th, and 5th labels have been finished.
[Case 3] Specified number of labels = 5,
A ribbon end is detected while the 3rd label is printed. Unfinished label length is less than 30 mm.
(1st)(2nd)(3rd)
↑
After issuing 3rd label completely, the printer stops printing, displaying “NO RIBBON 2”.
When printing is restarted, first the initial feed is performed, then 4th and 5th labels are
printed. Finally all of 5 labels have been finished.
5.4.2.15 MAXI CODE
・ TYPE1 Compatible with the current version
・ TYPE2 Special specification
The mode specified by the command may be different from the actual mode, depending on the status
of this parameter. Also, the data transmission method differs partly.
For details, refer to the B-EX Series External Equipment Interface Specification
5.4.2.16 XML
・ OFF Disable XML function
・ STD Standard specification
・ ORACLE Specification for Oracle
・ SAP Specification for SAP
・ STD EXT Standard specification (Use external memory)
・ ORACLE EXT Specification for Oracle (Use external memory)
・ SAP EXT Specification for SAP (Use external memory)
To Next Page
Loading...
