Toshiba B-EX4 SERIES - Page 137

5. SYSTEM MODE EO18-33027
5.4 PARAMETER SET
5-41
5.4.2.17 THRESHOLD SELECT
REFLECT Reflective sensor
TRANS. Transmissive sensor
5.4.2.17.1 REFLECT
・ MANUAL SET Threshold set in the threshold mode takes effect.
・ COMMAND SET Threshold set by command takes effect.
5.4.2.17.12 TRANS.
・ MANUAL SET Threshold set in the threshold mode takes effect
・ COMMAND SET Threshold set by command takes effect.
5.4.2.18 ENERGY TYPE
・ TRANSFER
・ DIRECT
This parameter is intended to make the printer perform appropriate printing for the supplies to be used.
Use of a different supply from the setting may cause poor printing.
For details of the appropriate settings, refer to the Supply Specification.
NOTE: If “CN” is selected for the parameter clear destination, the ENERGY TYPE parameter is not
displayed in the software set menu.
Applicable model: B-EX4T1-G/T-QM/CN C1.5 or later
B-EX4T2-G/T-QM/CN C1.3 or later
<Supplement>
When “CN” is selected for the parameter clear destination, “SX Compatible” is set for the thermal
transfer and “Standard” for the thermal direct as initial values. As this parameter is not displayed in the
menu, the initial values cannot be changed. (Initial values are fixed.)
5.4.2.18.1 TRANSFER
<B-EX4T1-G/T-QM/CN firmware version C1.4 or before>
・ Semi resin1 Semi-resin 1
・ Semi resin2 Semi-resin 2
・ Resin1 Resin 1
・ Resin2 Resin 2
・ Resin3 Resin 3 (“Resin3” shall not be selected for the B-EX4T1-T model.)
・ Reserve2 to Reserve6 Reserved
<B-EX4T1-G/T-QM/CN firmware version C1.5 or later>
・ Semi resin1 Semi-resin 1
・ Semi resin2 Semi-resin 2
・ Resin1 Resin 1
・ Resin2 Resin 2
・ Resin3 Resin 3 (“Resin3” shall not be selected for the B-EX4T1-T model.)
・ SX compatible SX compatible (*1)