5. SYSTEM MODE EO18-33027
5.4 PARAMETER SET
5-42
・ Reserve1 to Reserve4 Reserved
(*1) SX compatible” is a setting for securing the print quality equivalent to that of the B-SX, but it is
not supported by the print speed of 10 ips or faster. If 10 ips or faster print speed is specified,
the printer operation is not guaranteed. For details, refer to the Supply Specification for the B-
EX4T1 series.
<B-EX4T2-G/T firmware version C1.0C or before and B-EX6T2-G/T>
・ Wax1 Wax 1
・ Wax2 Wax 2
・ Semi resin1 Semi-resin 1
・ Semi resin2 Semi-resin 2
・ Resin1 Resin 1
・ Reserve1 to Reserve5 Reserved
<B-EX4T2-G/T firmware version C1.0D>
・ Wax1 Wax 1
・ Wax2 Wax 2
・ Semi resin1 Semi-resin 1
・ Semi resin2 Semi-resin 2
・ Resin1 Resin 1
・ Wax3 Wax 3
・ Semi resin3 Semi resin 3
・ Reserve1 to Reserve3 Reserved
<B-EX4T2-G/T firmware version C1.0E to C1.2, and B-EX4D2-G/T>
・ Wax1 Wax 1
・ Wax2 Wax 2
・ Semi resin1 Semi-resin 1
・ Semi resin2 Semi-resin 2
・ Resin1 Resin 1
・ Wax3 Wax 3
・ Semi resin3 Semi resin 3
・ Resin2 Resin 2
・ Reserve1 to Reserve2 Reserved
NOTE: Since the B-EX4D2 is a direct thermal printer, this parameter is not used for actual printing.
<B-EX4T2-G/T firmware version C1.3 or later>
・ Wax1 Wax 1
・ Wax2 Wax 2
・ Semi resin1 Semi-resin 1
・ Semi resin2 Semi-resin 2
・ Resin1 Resin 1
・ Wax3 Wax 3
To Next Page
Loading...
