Toshiba B-EX4 SERIES - Page 139

5. SYSTEM MODE EO18-33027
(Revision Date: Dec., 2017)
5.4 PARAMETER SET
5-43
・ Semi resin3 Semi resin 3
・ Resin2 Resin 2
・ Multiple type Multiple type
・ Reserve1 Reserved
<B-EX4T2-H firmware version C1.0F or before>
・ Resin1 Resin 1
・ Resin2 Resin 2
・ Reserve1 to Reserve8 Reserved
<B-EX4T2-H firmware version C1.1A or later>
・ Resin1 Resin 1
・ Resin2 Resin 2
・ Resin3 Resin 3
・ Reserve1 to Reserve7 Reserved
5.4.2.18.2 DIRECT
・ Standard Standard
・ Reserve1 to Reserve9 Reserved
5.4.2.19 PW SAVE TIME
Max.
value
Min. value Step Display Sign Integer
digit
Decimal
place
0-padding Unit of
measure
240 1 1 Decimal None 3 0 None Min.
5.4.2.20 RIBBON WIDTH
・ TYPE1 Type 1 (When using a 4-inch wide ribbon)
・ TYPE2 Type 2 (When using a ribbon whose width is narrower than paper width)
NOTE: Supported by the B-EX4T1-G/T-QM/CN C1.2 or later, B-EX4T2-G/T-QM/CN C1.2 or later, B-
EX4T2-H-QM/CN C1.1A or later, and B-EX4D2-G/T-QM/CN D1.1 or later
* This parameter is not used for the B-EX4D2-G/T.