5. SYSTEM MODE EO18-33027
5.6 TEST PRINT
5-54
5.6.9 Auto print (Reflective) / AUTO PRINT (REFL.)
The test print for manufacturing is started by the following conditions. The parameter setting content
and print density fine adjustment value are ignored.
The following test print is started by press any key except [CANCEL] key after each printing.
When [CANCEL] key is pressed, return to menu.
1 piece paper feed
3-dot slant line print
Barcode print
Movement contents
Character print
Issue piece5 pieces each 5 pieces each
203dpi：6”/sec
Print speed
305dpi：5”/sec
Sensor type Reflective sensor
Print method Thermal transfer
Issue type Continuous issue
Label pitch 76mm
Print density fine adjustment value ±0
To Next Page
Loading...
