5. SYSTEM MODE EO18-33027
5.8 RAM CLEAR
5-60
Parameter setting/Password setting
Function QM CN JA
Password enable/disable No initialization ← ←
Password value No initialization ← ←
Fine adjustment value setting
Function QM CN JA
Feed 0.0mm ← ←
Cut position 0.0mm ← ←
Back feed 0.0mm ← ←
X-coordinate 0.0mm ← ←
Print density (Thermal transfer) 0step ← ←
Print density (Direct Thermal) 0step ← ←
Ribbon (Rewind) 0step ← ←
Ribbon (Back tension) 0step ← ←
Reflective sensor 1.0V ← ←
Transmissive sensor 1.4V ← ←
To Next Page
Loading...
