5. SYSTEM MODE EO18-33027
5.11 RFID Module Setting
5-84
5.11.5.2 Multi word write / MULT WRITE
Gen2-compatible Hibiki tag (HITACHI) has a function which reduces the time to write data on the RFID
chips. This is called “Multi-word writes”. Use of this function enables a speed-up of the data write
operation. However, this function is unique to the Hibiki tag, and not usable with the other Gen2-
compatible chips.
・ Disable / OFF
・ Enable / ON
5.11.5.3 Carrier sense / CARRIER SENSE
The printer enters the carrier sense mode, and performs a carrier sense. In 5 seconds, environmental radio
wave of each channel is picked up for about 30 times (Enabled only when the B-SX704-RFID-U2 is used.)
LCD Display example
English
・ The left-most number indicates a channel number, and a percentage means the availability of the channel
which is determined by performing approx. 30 carrier senses. Thus, “100%” means that this channel is
not used by any other devices.
・ Strength （MAX）: Method to detect other carrier. There is strong radio origin if value is larger.
・
“MAX 0011” means the value of the maximum radio wave picked up.
・
The display can be scrolled up or down, from Channel 1 (1CH) to channel 9 (9CH)
・
Pressing the [ENTER] key causes the printer to perform a carrier sense again. To quit a carrier sense,
press the [CANCEL] key.
・
When the RFID module type is set to “NONE” or a communication cannot be established, a message,
“NON RFID MODULE”, is displayed.
・
When the RFID module type is set to other than U2, a message, “NOT AVAILABLE” is displayed.
・
When the RFID module type is set to U2 but effective data cannot be obtained, a message, “NO
RESPONSE” is displayed.
・
When the B-SX704-RFID-U2-US-R is used and if a RFID module’s destination code is not specified (user-
inaccessible setting), an “RFID CONFIG ERR” error message is displayed.
To Next Page
Loading...
