Toshiba B-EX4 - Page 173

6. ON LINE MODE EO18-33027
6. ON LINE MODE
6- 7
（Ex. 1）
[ESC]PC001;0A
00,0300,2,2,A,00,B[LF][NUL]
ＬＣＤ Display
（Ex. 2）
[ESC]T20G
30[LF][NUL]
ＬＣＤ Display
（Ex. 3）
[ESC] PC002;0100,0300,15,15,A,00,00,J0101,+000000000A
,Z10,P1[LF][NUL]
ＬＣＤ display
(*2) When command error is displayed, the code except 20H-7FH, A0H-DFH are displayed as “?” (3FH).
(*3) When the ribbon near end detection is enabled, the error LED blinks 1Hz (50msec ON, 500msec
OFF) during ribbon near end and condition is from No.1 to No.3.
(*4) The battery check is not work when resetting and RTC is not mounted.
(*5) It is necessary to set any following item to use RTC function at low battery condition.
1． Turn off printer power from error condition, turn of printer by system mode, set date and time of
RTC, reset printer, and change to online condition.
2． Move to user mode by holding down [RESTART] key for 3 seconds, reset printer, set to online
condition, and set date and time by command.
* It is possible to printer by setting date and time till turning off printer.
Commanderror
PC001;0A00,0300,2,2,A
,00,B
Commanderror
CommandError
T20G30
Commanderror
PC002;0100,0300,15,15
,A,00,00,J0101,+00000
Commanderror
Command error