Toshiba B-EX4 - Auto Diagnostic; AUTO DIAGNOTICS

5. SYSTEM MODE EO18-33027
5.3 SELF-DIAGNOSTIC TEST
5-16
5.3.2 Auto Diagnostics/AUTO DIAGNOSTICS
The printing procedure of “AUTO DIAGNOSTIC” of “DIAG.” is same as 「5.3.1 Counter, Parameter/
MAINTENANCE COUNT」.
The manu layer from top menu of system mode to AUTO DIAGNOSTICS is below.
MENU ITEM
System Mode / SYSTEM MODE
<1>Diagnostics / <1>DIAG.
Auto Diagnostics / AUTO DIAGNOSTIC
Print method / PRINT TYPE
Thermal transfer / TRANSFR
Direct thermal / DIRECT
Cut setting / CUT TYPE
Disable / OFF
Enable / ON
Print / CHECKING & PRINT
If error occur during printing, the error message is displayed, the error LED turns on and the onlineLED
turns off. The erro can be canceled by [ENTER], [CANCEL] or [MODE] key, but printer did not perform
re^printing.
• AUTO SELF DIAG. PRINT CONTENTS
PROGRAMB-EX4T1-T
MAINXXXXXXXXXV1.0A:1A00
BOOTXXXXXXXXXV1.0:8500
HTMLXXXXXXXXXV1.0:6100
FONT5600
KANJINONE:0000
NONE:0000
EEPROM256B
SDRAM32MB
SENSOR100000000,00000111
SENSOR2[H]23 ﾟ C[A]22 ﾟ C
[R]4.2V[T]2.5V[E]0.6V
HEAD[RANK]7305DPI
EXP.I/ONG
EX.232CNG
RFIDOK#00RV972(EU0)R01
WLANOKVer1.1.3
MAC00-11-22-33-44-55
RTCNG
USBMEMORYNG

BASICMZ-SX4-MV10F.V1.0F:7479
BASICSZ-SX4-SV10E.V1.0E:AD36