4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33031
4.1 DISC CUTTER (B-EX206-QM-R)
4- 8
6. Remove 2 screws and Cutter Cover
7. Put the Cord Bush onto the Harness Ass’y in the orientation as shown below.
8. Attach the Cable Clamp to the printer base.
Fasten the Harness Ass’y with the Cable Clamp.
NOTE: Make sure the wires will not touch or obstruct any moving parts.
Cord Bush
Cable ClampPrinter Base
Harness Ass’y
Cable Clamp
Plastic Head Screw
Plastic Head Screw
Cutter Cover
To Next Page
Loading...
