4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33031
4.3 PEEL-OFF MODULE (B-EX906-H-QM-R)
4-18
9. Align the dowel on the bottom of the Rewind Full Sensor with the dowel hole in the base.
Secure the Rewind Full Sensor to the printer base with the ST-3x6 screw.
10. Fit the Cord Bush to the Rewinder Harness and Rewind Full Sensor Harness together, in the
orientation shown below. Then fit the Cord Bush into the hole.
Rewinder Harness
Rewind Full Sensor
ST-3x6 Screw
Cord Bush
Cord Bush
Hole
To Next Page
Loading...
