4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33031
4.3 PEEL-OFF MODULE (B-EX906-H-QM-R)
4-20
13. Connect the Rewinder Harness to J11 on the Main PC board
14. Connect the Rewind Full Sensor Harness to the 3-pin connector of the Rewinder Harness.
15. Fasten the harness of the 4-pin Connector of the Rewinder Harness with Cable Clamp and Cable
Protector. And then insert the 4-pin Connector of the Rewinder Harness into the hole of the main frame.
16. Fit the Cord Bush to the 4-pin Connector of the Rewinder Harness, in the orientation shown below.
Then fit the Cord Bush into the hole.
Main PC Board
Rewinder Harness
J11
3-pin Connector of the
Rewinder Harness
Cable Protector
4-pin Connector of the
Rewinder Harness
Cable Clamp
Cord Bush
Hole
4-pin Connector of the
Rewinder Harness
To Next Page
Loading...
