4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33031
(Revision Date: Mar. 1, 2017)
4.8 UHF RFID KIT (B-EX706-RFID-U4-US/EU/AU-R)
4-49
Table 1 (Normal print)
A (mm) C (mm) Antenna Shield Label Shielding plate
10 to 20 10 to 18 Front F Required
over 20
10 to 34 Front F Disabled
34 to 41 Center C Disabled
over 41 Rear R Disabled
Table 2 (Offset print)
A (mm) A+C (mm) Antenna Shield Label Shielding plate
10 to 20
10 to 34 Front F Required
34 to 38 Center C Disabled
over 20
20 to 34 Front F Disabled
34 to 41 Center C Disabled
over 41 Rear R Disabled
- Offset printing Characteristics is the mode of execution of writing for one piece back word tag from the
printing Tag and it should be effective for plural RFID tag is printing continuously.
- When this function is enabled, the back feed to write data is unnecessary and the throughput should be
improved, due to the one piece back word Tag from printing label should be just on the RFID Antenna
when the around 20mm pitch tag is used.
- Offset printing function is available, when the @003 command (Writing before RFID ISSUE feed length
setting command)
To Next Page
Loading...
