4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33031
(Revision Date: Mar. 1, 2017)
4.8 UHF RFID KIT (B-EX706-RFID-U4-US/EU/AU-R)
4-50
Antenna position: Center
Shielding plate: Not required
Antenna position: Rear
Shielding plate: Not required
2. Move the antenna in the middle position and
observe proper alignment as shown in the
figure above. Attach the two screws back
with the new antenna position.
1. After the antenna shield and antenna screws
have been removed, detach the connector of
the PCB from the antenna.
Connector
2. Reroute the black wire to the other side
as shown in the figure above.
Black wire
3. Re- connect the black wire to the
antenna as shown in figure above.
4. Attach the antenna and secure with 2 screws,
the proper alignment shown in the figure
above.
1. Remove the antenna shield as per Step 1 to
2 of Front Position (Antenna Shield Disable),
and remove 2 screws as shown.
Antenna
Screws
Antenna Shield
Screws
Screws
To Next Page
Loading...
