4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33031
(Revision Date: Mar. 1, 2017)
4.8 UHF RFID KIT (B-EX706-RFID-U4-US/EU/AU-R)
4-51
4.8.6 RFID Module Settings
After installing the RFID Module on the printer, configure the RFID module settings in the printer system
mode.
How to enter the System Mode
Contents of the RFID Menu
Menu Sub menu Parameter
RFID TEST ID READ
MODULE MODULE TYPE
COUNTRY
TAG
RF CHANNEL
RETRY RETRY POSITION
RETRY LABELS
READ RETRY
WRITE RETRY
UHF SETTING POWER LEVEL
Q VALUE
AGC THRESHOLD
WRITE AGC THRESHOLD
WRITE RETRY MIN AGC
OTHER TAG CHECK
MULTI WRITE
Key functions in the system mode
Key Function
[MODE] Returns to the mode menu screen.
[CANCEL] or
[FEED]+[RESTAR]
Returns to the upper hierarchy.
[ENTER] or [PAUSE] Displays a next screen.
Saves the setting and returns to the upper hierarchy.
[UP] or [RESTART] Moves the cursor upward.
Increases a value.
[DOWN] or [FEED] Moves the cursor downward.
Decreases a value.
[LEFT] Moves the cursor to the left.
[RIGHT] Moves the cursor to the right.
Power OFF
SYSTEM MODE
<5>RAM CLEAR
<6>INTERFACE
<7>RFID
<8>RTC
SYSTEM MODE
<0>RESET
<1>DIAGNOSTIC
<2>SET PARAMETERS
<3>TEST PRINT
Press [DOWN] until
“<7>RFID” is
highlighted.
Turn on the printer while holding
down [FEED] & [PAUSE] or
[MODE].
Press [ENTER].
To Next Page
Loading...
