4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33031
(Revision Date: Dec., 2018)
4.9 4” ROTARY CUTTER (B-EX206-R-QM-S)
4-67
6. Secure the Cutter Unit with the M-4x8 screws.
7. Attach the Cutter Cover to the Cutter Unit with the two screws so that the tab of the Cutter Cover turns
on the Cutter Cover Open Switch.
NOTES: 1. Be careful not to pinch the cutter harness by the cutter cover.
2. Make sure that the anti-static brush is protruding from the media outlet.
4.9.4 Wiring of the Harness Ass’y
1. Pass the Harness Ass’y through the Cable Protector.
Cutter Cover
M-4x8 Screw
Cable Protector
Harness Ass’y
Cutter Cover Open Switch
Tab
Screw
nti-static brush
Inside of the Cutter Cover
To Next Page
Loading...
