9. NETWORK EO18-33030
9.2 SNMP Trap
9-3
9.2 SNMP Trap
If you enable SNMP Trap in B-FV Setting Tool, you can use it to monitor your network printers. Your
printer sends the trap data packet back if any error or warning has occurred. Every error or warning
has its unique ID, which is bcpStatusID included in the trap OID: 1.3.6.1.4.1.1129.1.2.1.1.2.1.X (X:
value of bcpStatusID). The ID the SNMP trap returned corresponds to your printer status listed
below.
Printer Status bcpStatusID Printer Status bcpStatusID
Idle 0 Format error 51
Head open 1 Write error 50
Pause 4 Memory full 54
Communication error 7 Stack overflow No output
Paper jam 11 Stacker error No output
Cutter error 12 Low battery 36
Paper end 13 In operation 2
Head open error 15 Waiting to be stripped 5
Printhead broken element 17 Command error 6
Excessive printhead temperature 18 Normal end of label issue No output
Cover open 24 Normal end of label feed No output
Save mode 55 End of void pattern printing No output
To Next Page
Loading...
