2. PRINTER SETUP ENGLISH VERSION EO1-33048
2.7 Setting an Operating Environment
E2-23
2.7.1 Parameter Setting
(Cont.)
After setting the control code for Control Code 1, press the [PAUSE]
key to show the CONTROL CODE2 screen. In a same manner, press the
[PAUSE] key after setting the control code for Control Code 2 to display
the CONTROL CODE3 screen.
Press the [PAUSE] key after setting the control code for Control Code 3.
(11) Strip Wait Status Selection
This parameter is to choose when the printer sends a strip wait status
(05H) to a host in response to a status request command.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the Strip Wait Status, press the [PAUSE] key.
(12) FEED Key Function Selection
This parameter is to choose the function of the [FEED] key.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the FEED key function, press the [PAUSE] key.
CONTROL CODE1
CONTROL CODE2
CONTROL CODE3
[PAUSE]
[PAUSE]
<2>PARAMETER SET
PEEL OFF STS OFF
[RESTART]
[FEED]
PEEL OFF STS ON
A strip wait status is sent when the printer
receives the next issue command and the
previously printed label is waiting to be removed.
PEEL OFF STS OFF
A strip wait status is sent when a printed label
is waiting to be removed.
<2>PARAMETER SET
FEED KEY FEED
FEED KEY FEED
FEED KEY PRINT
[RESTART]
[FEED]
The [FEED] key will feed one media when
pressed.
The [FEED] key will print the data in the
Image Buffer (The last printed data)
To Next Page
Loading...
