2. PRINTER SETUP ENGLISH VERSION EO1-33048
2.7 Setting an Operating Environment
E2-28
2.7.1 Parameter Setting
(Cont.)
(21) Plug & Play Selection
This parameter is to choose whether to enable a Plug & Play function.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a Plug & Play, press the [PAUSE] key.
(22) Label End/Ribbon Error Selection
This parameter is to choose a printing process when a label end or ribbon
error is detected.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a Label End/Ribbon Error type, press the [PAUSE] key.
NOTE:
f the printer and the PC are
connected by USB, plug & play will
be automatically enabled, regardless
of the setting of this parameter.
<2>PARAMETER SET
PLUG & PLAY OFF
PLUG & PLAY OFF
PLUG & PLAY ON
[RESTART]
[FEED]
Unavailable
Available
<2>PARAMETER SET
LBL/RBN END TYP1
LBL/RBN END TYP1
LBL/RBN END TYP2
[RESTART]
[FEED]
TYPE1: When a label end/ribbon error is
detected in the middle of printing, printing is
immediately paused.
TYPE2: When a label end/ribbon error is
detected in the middle of printing, the printer
prints the half-finished label as far as
possible, and stops when the next label is at
the home position.
To Next Page
Loading...
