Toshiba B-SX5 Series - 6.7 RAM CLEAR

- 99 -
6.6 SENSOR DISPLAY/ADJUSTMENT
6.6.1 Sensor Display/Adjustment Operation Example
< 1 > D I A G . V 1 . 0 A
< 2 > P A R A M E T E R S E T
< 3 > A D J U S T S E T
< 4 > T E S T P R I N T
< 5 > S E N S O R A D J .
< 5 > S E N S O R A D J .
[ H ] 2 8 ° C [ A ] 2 8 ° C
< 5 > S E N S O R A D J .
[ S ] 2 5 ° C
< 5 > S E N S O R A D J .
[ R E F L E C T ] 3 . 5 V
< 5 > S E N S O R A D J .
[ R E F L E C T ] 4 . 8 V *
[FEED] [PAUSE]
(11) System mode menu display
(Sensor display/adjustment)
(13) Thermal head temperature/open-air
temperature display
[FEED]
(7) System mode menu display
(
Fine ad
j
ustment value settin
g)
(4) Press the [FEED] key.
(5) System mode menu display
(Parameter setting)
(3) The self-test menu is displayed.
(2) While holding the [FEED] and [PAUSE]
keys down, turn the power on.
(1) Power off state
Power OFF
(6) Press the [FEED] key.
[FEED]
(8) Press the [FEED] key.
[FEED]
(12) Press the [PAUSE] key.
[PAUSE]
(19) “*” is displayed when the reflective
sensor adjustment is complete.
(17) Reflective sensor adjustment value
display:
Load tag paper. (The black mark
should not cover the sensor.)
[RESTART]
or
[FEED]
[PAUSE]
(18) Hold down the [RESTART] or [FEED]
key for 3 seconds or more.
(14) Press the [PAUSE] key.
[PAUSE]
(20) Press the [PAUSE] key.
(15) Heat sink temperature display
(16) Press the [PAUSE] key.
[PAUSE]
(9) System mode menu display
(
Test print
)
[FEED]
(10) Press the [FEED] key.
*: When the Part No. of the MAIN PC Board is
7FM00503x00, this value is not displayed.