- 106 -
Parameter Initial Value
QP type English
QQ type English
CN type English
Language for LCD messages
QM type English
Forward feed standby after an issue OFF
Forward feed standby action MODE 1
Head-up operation in cut issue mode, or use of the
rewinder
OFF
(Head-up operation is not operated/
the rewinder is not used.)
Installed solenoid type TYPE 2 (Stronger pull force type)
B-SX4
OFF
Ribbon saving system
B-SX5
ON (TAG): When the head lever
position is “TAG”.
Control code type Auto
Peel-off wait status selection OFF
[FEED] key function FEED (One label is fed.)
Kanji code TYPE1
Euro code B0H
Automatic head broken dots check OFF
Centronics ACK/BUSY timing TYPE1
Web printer function OFF
Reset process when the nInit signal is ON ON
Ribbon near end detection setting OFF
Expansion I/O operation mode TYPE1
QQ type ECP Centronics operation mode
Other than QQ type SPP
Plug-and-play operation
mode
QQ type ON
Other than QQ type OFF
Label end/ribbon end process setting TYPE1
Pre-peel-off process setting OFF
Back feed speed setting 3 ips
MaxiCode specification setting TYPE1
B-SX4 V2 type: TPH104R7 or equivalent
Print head type setting
B-SX5 V2 type: TPH128R5 or equivalent
Status response ON
Label pitch 76.2 mm
Effective print length 74.2 mm
B-SX4
104.0 mm
Effective print width
B-SX5
128.0 mm
Print type Thermal transfer print mode
Sensor type Transmissive sensor
B-SX4
6”/sec.
Feed speed
B-SX5
5”/sec.
Issue mode Batch
PC-save automatic call
ON
Save No. on the CPU board (ID) 01
To Next Page
Loading...
