Toshiba B-SX5 Series - Page 13

- 10 -
< 2 > P A R A M E T E R S E T
C O D E E S C , L F , N U L
< 2 > P A R A M E T E R S E T
P E E L O F F S T S O F F
< 2 > P A R A M E T E R S E T
F E E D K E Y F E E D
< 2 > P A R A M E T E R S E T
K A N J I C O D E T Y P E 1
< 2 > P A R A M E T E R S E T
E U R O C O D E B 0
< 2 > P A R A M E T E R S E T
A U T O H D C H K O F F
< 2 > P A R A M E T E R S E T
A C K / B U S Y T Y P E 1
< 2 > P A R A M E T E R S E T
W E B P R I N T E R O F F
< 2 > P A R A M E T E R S E T
I N P U T P R I M E O N
< 2 > P A R A M E T E R S E T
R B N N E A R E N D 7 0 m
[PAUSE]
(41) Kanji code selection:
Select the Kanji code using the [FEED]
and [RESTART] keys.
(42) Press the [PAUSE] key.
[PAUSE]
(39) [FEED] key function setting:
Make the setting for the function of the
[FEED] key using the [FEED] and
[RESTART] keys.
(40) Press the [PAUSE] key.
[PAUSE]
(45) Automatic head broken dots check setting:
Set the automatic head broken dots check
using the [FEED] and [RESTART] keys.
(46) Press the [PAUSE] key.
(48) Press the [PAUSE] key.
[PAUSE]
[PAUSE]
(43) Euro code setting:
Set the Euro code using the [FEED]
and [RESTART] keys.
(49) Web printer function setting:
Set the function for a web printer using
the [FEED] and [RESTART] keys.
(51) Reset process when the nInit signal is ON:
Set the reset process using the [FEED]
and [RESTART] keys.
(53) Ribbon near end detection setting:
Select the remaining ribbon length to be
detected as a ribbon near end state using the
[FEED] and [RESTART] keys.
(44) Press the [PAUSE] key.
(50) Press the [PAUSE] key.
[PAUSE]
(47) Centronics ACK/BUSY timing setting:
Set the ACK/BUSY timing using the
[FEED] and [RESTART] keys.
[PAUSE]
(52) Press the [PAUSE] key.
[PAUSE]
(54) Press the [PAUSE] key.
[PAUSE]
(37) Peel-off wait status selection:
Set the peel-off wait status selection using
the [FEED] and [RESTART] keys.
(38) Press the [PAUSE] key.
[PAUSE]
(35) Control code selection:
Select the control code using the
[FEED] and [RESTART] keys.
(36) Press the [PAUSE] key.