Toshiba B-SX5 Series - 5.8 FINE ADJUSTMENT VALUE SETTING

- 14 -
(7) RS-232C transmission control method selection (XON+READY)
• XON/XOFF protocol (An XON is not output when the power is
on and an XOFF is not output when the
power is off)
• READY/BUSY (DTR) protocol (An XON is not output when the power is
on and an XOFF is not output when the
power is off)
• XON/XOFF + READY/BUSY (DTR) protocol (An XON is output when the power is on
and an XOFF is output when the power is
off)
• XON/XOFF protocol (An XON is output when the power is on
and an XOFF is output when the power is
off)
• RTS protocol (An XON is not output when the power is
on and an XOFF is not output when the
power is off)
(8) Language selection for LCD messages (LCD)
• ENGLISH
• GERMAN
• FRENCH
• DUTCH
• SPANISH
• JAPANESE
• ITALIAN
NOTE: When Japanese is selected, one part of the character codes is different. For
details, refer to the External Equipment Interface Specification (TAA-1380).
(9) Setting for forward feed standby (FORWARD WAIT)
• ON (with automatic feed standby)
• POSITION (Fine adjustment value setting for the stop position after a forward feed)
• OFF (without automatic feed standby)
NOTE: When it is set to ON, if the printer is in the idle state for 1 second or more after a
label is issued, the printer automatically performs an approximately 13.7-mm
forward feed, then stops.
(10) Setting for the forward feed standby action (FW/BK ACT.)
• MODE 1 (Stops after 13.7-mm forward feed.)
• MODE 2 (Stops after 6-mm back feed and 3-mm forward feed.
(Only when the cut mode, thermal transfer, and feed gap sensor are
selected.) In other cases, the printer stops after 13.7-mm forward feed.)
(11) Setting for head-up operation in cut issue mode, or for using the rewinder in batch issue
mode (HU CUT/RWD.)
• ON (The head is lifted, or the rewinder is used.)
• OFF (The head is not lifted, or the rewinder is not used.)
(12) Installed solenoid type setting
• TYPE 1
• TYPE 2 (Stronger pull force type)