Toshiba B-SX5 Series - Maintenance Counter;Various Parameters Printout; Self-Test Items; Various Parameters

- 43 -
6.2.2 Self-test Items
(1) Maintenance counter/various parameters printout
c Maintenance counter
• Total label distance covered (cannot be cleared)
• Label distance covered
• Print distance
• Cut count
• Head-up/down count
• Ribbon motor drive time
• Head-up solenoid drive time
• RS-232C hardware error count
• System error count
• Momentary power interruption count
d Various parameters
[Value programmed on the PC]
• Feed fine adjustment value
• Cut position (or strip position) fine adjustment value
• Back feed fine adjustment value
• Print density fine adjustment value (Thermal transfer print mode)
• Print density fine adjustment value (Direct thermal print mode)
• Ribbon motor drive voltage fine adjustment (Rewind)
• Ribbon motor drive voltage fine adjustment (Back tension)
[Value programmed using the keys]
• Feed fine adjustment value
• Cut position (or strip position) fine adjustment value
• Back feed fine adjustment value
• Print density fine adjustment value (Thermal transfer print mode)
• Print density fine adjustment value (Direct thermal print mode)
• Ribbon motor drive voltage fine adjustment (Rewind)
• Ribbon motor drive voltage fine adjustment (Back tension)
• X-coordinate fine adjustment value
• Reflective sensor manual threshold fine adjustment
• Transmissive sensor manual threshold fine adjustment
• Character code type
• Font “0”
• Communication speed
• Data length
• Stop bit length
• Parity
• Transmission control method
• Language for LCD messages
• Forward feed standby after an issue
• Forward feed standby action
• Head-up operation in cut issue mode/use of the rewinder
• Installed solenoid type setting
• Ribbon saving system setting
• Control code type
• Peel-off wait status selection
• [FEED] key function
• Kanji code type
• Euro code set value
• Automatic head broken dots check setting
• Centronics ACK/BUSY timing setting